A failure has occurred with the option network interface card. Remove the press roller 1 from the fuser unit 2. Figure Installing the option memory card FS Cleaning The Printer The main charger unit should be cleaned in its two parts, the main charger wire and grid See figure below. Unlatch two hooks 3. Lenses D and diversion mirror E are housed in the laser scanner unit B. Page – Undulated printing at the left edge sca

Uploader: Tukazahn
Date Added: 2 October 2008
File Size: 56.25 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 57341
Price: Free* [*Free Regsitration Required]

If you ship the developer, pack it in the shipping container specifically kyocera fs-1900 with the printer. Kyocera fs-1900 have an account? A-3 Cassette feeding, two letter size papers, face-down tray output Installing The Dimm 3.


Turn kyocera fs-1900 switch on See page Installing The Option Memory Card compactflash 2. Replacing The Developer To pack the developer 1 in the packing carton, first flap down the magnet kyocera fs-1900 protective cover 2.

Laser Scanner Unit Compensates the vertical angle at which the laser beam hits on of the polygon mirror segments. Figure Installing the waste toner box FS Remove the upper exit guide kyocera fs-1900 while unlatching three latches 2.


Download Center

Suggested causes Corrective action False paper size Defective paper size switch. Figure Removing the operator panel FS Page Appendix C Contents Kyocera fs-1900 interface Figure Installing the toner container Kyocera fs-1900 Insert the memory card 1 in the memory card slot 2 at the right bottom of the printer.

Remove the solenoid actuator 6. Drum Cleaning Mode Drum is cleaned by the cleaning blade in the drum unit.

Remove the thermistor 2. Draw the paper transfer unit from the printer. Turn the paper kyocera fs-1900 unit 1 over.

Kyocera FS-1900 Service Manual

With the label side down and pivoting on kyocera fs-1900 middle of kyocera fs-1900 container, thoroughly shake the toner container in the direction of the arrows ten times or more to loosen and mix the toner inside. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

Figure Opening the controller unit FS If Auto Continue is set to On, printing will be automatically resumed after a fss-1900 period of time. Remove heat gear Z36 3, heat R bush 1, and heat L bush 2 from the heat roller 4. Page Appendix C Cleaning of the main charger can be done without needing any kyocera fs-1900 thanks to its self-cleaning system.


Remove the power supply unit 9 from the kyocera fs-1900 supply unit fe-1900 0.

Printer: Kyocera FS | OpenPrinting – The Linux Foundation

Provide an antistatic discharging device, such as a wrist strap, that can kyocera fs-1900 discharge your body before touching those components. B is approximately 0.

Figure Removing the power supply unit FS KP or power supply unit. Due to being high-voltage scorotron kyocera fs-1900, the main charger wire B can get contaminated by oxidization after a long run. The specified file does kyocera fs-1900 exist in the hard disk Microdrive.

Usb Interface 5 meters 16 feet.